Anita's quilts and quilting

A professional longarm machine quilter for hire and some of the work I've done.

Use the scrap batting

..
Have you ever wondered what to do with this? Does your batting scraps tend to pile up when you aren’t looking? (These are the trimmings from individual battings used for customer quilts.) The batting is too good and too expensive to just fill up a land fill area somewhere.


Have you ever had a customer bring you pieced together batting that was zig-zag stitched like this? Is that how you would do it?


Here is a better way. First, take out some of your light weight iron on interfacing. You know, the stuff you stabilize fabric with before constructing a garment or t-shirt quilt. Cut some 2 inch strips. These could be larger or smaller, depending on your own preference. I just happen to like the 2 inch size. Try this size until you get comfortable with the technique.


Next, find two pieces of batting that are close to the same length, mine are usually about 92 inches because that’s what is used for the customer quilts. The width varies from about 4 inches to about 12 inches. The length or width really doesn’t matter but to save time I try to match the length. Bigger is nice but I like to use up all the pieces of batting, even the smaller pieces.

Now layer your batting with two pieces overlapping an inch or two like this. I’m working one small section at a time as I move along the length of the batting.. It’s important to have the batting on an ironing surface so you can do the next step.


Now go searching for that vintage fabric cutter. (Like the one in this photo below.) If you don’t remember how to use those things….the thumb goes in the smaller handle with the fingers in the other handle. You work them by opening and closing your hand. Keep trying, you’ll figure it out.

No, you really can’t use a rotary cutter on an ironing board safely. It would cut the ironing board fabric to shreds. Ok now…..start cutting a wavy line down the over lapped batting making sure you cut both layers together. Don’t make your curves real sharp…..just a gentle curve will do. Why do we use curves instead of straight line cutting? Hmm….it’s to hide the break in the batting from the outside of the quilt. A straight line tends to cause a crease in the top while a curved line doesn’t.


Remove the tiny cut pieces and lay the interfacing over the curved cut edges. Press the interfacing to the batting with the warm iron. Make sure it’s hot enough to fuse but not hot enough to melt the batting. Be sure there isn’t even the tiniest gap between the pieces of batting before pressing the interfacing to it. These tiny gaps have a way of looking hugh in a finished quilt.


After ironing it will look like this. It will be very sturdy yet it won’t leave a hard line like zig zag stitching does. And…you won’t have to fight with the batting to sew it with your domestic machine.


Once that section has been stabilized, move on to the next section and repeat the process.


This is how your batting should look from the other side after the fusing is done.


It’s important to fuse like types and weights of batting together for the best use. If you start mixing up types and weights you won’t get a nice looking quilt. Fusing batting together this way will save you a few dollars here and there as you create your charity quilts. Once quilted the batting will stay together as long as the quilt stays together.

I keep the tiniest scraps to use in a variety of crafts. I’ll describe some of those later.

Advertisements

Information

This entry was posted on November 16, 2007 by in QUILTS - STASH BUSTING.

How often do I post?

November 2007
S M T W T F S
« Oct   Dec »
 123
45678910
11121314151617
18192021222324
252627282930  

Monthly archives

List of blog categories

Enter your email address to subscribe to this blog and receive notifications of new posts by email.

Join 74 other followers

Follow Anita's quilts and quilting on WordPress.com

Blog Stats

  • 85,506 HITS
%d bloggers like this: